Jetcat P180 NX - Thrust: 40 lb, Now Features a Brushless Fuel Pump
The JetCat P180-NX, comprises not only an engine sided integrated brushless- and fully encapsulated fuel pump but also features a brushless starter / generator system. As the rotor of the brushless fuel pump is running in the fuel, the otherwise necessary shaft seals can be omitted. The starter / generator operates completely mechanical contact free to the turbine shaft. The coupling of starter to engine rotor is resistant to wear and dirt (no slippage of the starter clutch by oil/dirt, no O-ring wear possible).
Jetcat P180-NX turbine engine, made in Germany
MSRP Retail $3,595.00
Max Thrust: 40 lbs@126,000 rpm
Rest Thrust: 5N
Engine Weight: 4.9 lbs
RPM Range: 33,000 to 125,000
Max Temp: 730C
Fuel Rate at Full Power: 20.6 fl oz per minute
Fuel Consumption: 610ml/min (full load)
Fuel: Jet A1, kerosene
Lubrication: approximately 5% synthetic. Turbine oil in the fuel
Maintenance cycle: every 25 hours Cost: $300
Jetcat P180-NX includes:
The future is here! After starting the engine, the engine battery is recharged via the generator with high power. The engine side electronics controls the charging current / voltage. The optional JetCat BMS system can be used to also recharge the receiver batteries. In this configuration, the BMS-system ensures that the receiver batteries are always fully charged upon the next engine startup. The charging of the receiver batteries will continue until these are completely full, even if the RC-system of the model should have been powered down. Includes 9.9V LiFe battery. A123 compatible! Comes with everything you need to install into your plane.
Now Includes the ECU V10.0
The updated ECU comprises a high speed digital power bus for control and power supply of all engine peripherals (e.g. engine, fuel pump, solenoids, smoke pump, lighting systems, etc. ) with a minimum of wiring connections.
An on board precision pressure and ambient temperature sensor allows for optimum engine control, independent to environmental conditions.
Includes JetCat Mini-GSU
The JetCat Mini-GSU is an optional miniature Ground Support Unit (GSU). It comprises a 2x16 character alphanumeric backlit LCD display and 10 control keys.
Function wise it can be used as a 100% replacement for our normal GSU. Its small form factor and weight makes it ideally suited for permanent installation in the model. Connection to ECU`s up to Version 6.0 is via a 8-pin miniature flatcable connector directly to the LED-I/O interface. Connection to ECUs from Version 10.0 is via a 6-pin miniature flatcable directly to the ECU or the LED-I/O interface or 8-pin flat cable to JetCat I/O-interface with charging option.
* Fuel tubing, tubing connector set, filters, and cable set
* Turbine mounting clamp
* Detailed instruction manual
* 3 Year warranty
Why Buy From GlobalJet.Club Instead of Manufacturer?
- Timezone communication challenges
- How's your German language speaking skills?
- We act on your behalf for all customer service.
- Our volume buying gets you better package deals
- At event support, we can provide direct help.
- Save money and frustration, deal directly with GlobalJet.Club